A brick calculator works out roughly how many bricks you'll need to build a wall, based on the wall's face area and the number of bricks it takes to cover one square metre for your brick size and mortar joint thickness. This is the figure you need before ordering bricks for a feature wall, boundary wall, veneer cladding or garden wall, and getting it close is important because bricks are often sold in batch quantities and colour-matching a top-up order later (especially for a discontinued batch or weathered colour) can be difficult.
For a standard Australian metric brick (roughly 230mm x 76mm face) laid with a typical 10mm mortar joint, around 50 bricks are commonly needed per square metre of single-skin wall โ this is a widely used rule of thumb in the Australian building trade, though it can shift slightly with different joint thicknesses or brick sizes. This calculator uses that standard figure by default, or lets you enter your own bricks-per-square-metre rate if you're using a non-standard brick size.
Why a wastage allowance matters
Even on a straightforward wall, you'll lose some bricks to cuts at corners, openings and edges, plus occasional breakages in handling. A wastage allowance of roughly 5-10% on top of the exact theoretical count is a commonly used buffer in the Australian trade, with more complex walls (lots of openings, curves, or decorative patterns) often needing a higher allowance. It's generally cheaper to over-order slightly in one go than to go back for a small top-up later, both due to delivery fees and the risk of a batch colour mismatch.
Double-skin (cavity) walls need roughly double the single-skin brick count since there are two leaves of brickwork, so make sure you select the right wall type when estimating a full cavity wall rather than a single-skin veneer or garden wall.
Don't forget mortar and other materials
Bricks are only part of the materials list โ you'll also need enough sand and cement (or pre-mixed mortar) for the joints, plus wall ties, flashing and damp-proofing for a structural cavity wall. Many brick suppliers can provide a combined materials estimate once you know your brick count, which is worth getting before finalising your order.
Frequently asked questions
For a standard Australian metric brick with a 10mm mortar joint, roughly 50 bricks per square metre is a commonly used figure for single-skin brickwork โ this can vary slightly with brick size and joint thickness.
A common range is 5-10% for a straightforward wall, with more cuts, corners or openings pushing that higher โ check with your bricklayer or supplier for a job-specific allowance.
Yes, roughly โ a cavity wall has two separate brick leaves, so you'll need close to double the single-skin brick count for the same wall area.
Not automatically โ for best accuracy, subtract the area of any door and window openings from your wall area before entering the length and height, or adjust your final figure down accordingly.