๐Ÿ‡ฆ๐Ÿ‡บ Free Australian calculators โ€” rates updated for FY2026โ€“27
Home Improvement & Construction

Decking Calculator

Work out how many decking boards, joists and fixings you need for your build, plus a rough material cost.

๐Ÿ•’ Updated September 2026๐Ÿ‡ฆ๐Ÿ‡บ Australia-specific๐Ÿ’ฏ Free, no signup

๐Ÿงฎ Calculate your decking materials

Ordering decking materials usually comes down to two numbers: how many lineal metres of board you need in total (which depends on board width, the gap between boards, and the deck's dimensions), and how many joists you need underneath to support them at the right spacing. Get either one wrong and you're either back at the hardware store mid-build or sitting on a pile of expensive offcuts.

This calculator handles both, plus a rough fixing (screw) count and an optional total material cost if you know your price per lineal metre.

Why joist spacing matters more than people think

Joist spacing isn't just a rule of thumb โ€” it's governed by the specific decking product's span table, which accounts for board thickness, material (hardwood vs composite vs softwood) and expected load. Going wider than the product's rated spacing risks bounce, sagging and premature board failure; going tighter than necessary just wastes timber and labour. Always check your specific product's span table rather than assuming a single spacing fits everything.

Don't forget substructure and fixings

This calculator focuses on decking boards, joist count and an estimated fixing quantity โ€” it doesn't cover bearers, stumps/footings, joist hangers, or the substructure timber sizing, which depends on your deck's height, span and local wind/soil conditions. For anything load-bearing or more than a step off the ground, get your substructure design checked against the relevant building code (and, in most states, a building permit) before you start.

Frequently asked questions

How much decking do I need for a 6m x 4m deck?+

It depends on board width and gap โ€” with a 90mm board and 5mm gap running the 6m length, you'd need roughly 42 board rows across the 4m width, each 6m long, plus around 5% extra for wastage. Enter your exact dimensions above for a precise figure.

What joist spacing should I use for composite decking?+

Many composite boards require closer spacing than timber โ€” commonly 300-400mm centres โ€” because composite is generally less stiff than hardwood at the same thickness. Always check your specific product's published span table rather than assuming a timber spacing applies.

How many screws do I need per square metre of decking?+

As a rough guide, most hidden or exposed fixing systems use roughly 2 fixings per board per joist crossing โ€” this calculator estimates total fixings from your total lineal metres of board, but check your specific fixing system's recommended spacing.

Do I need a building permit for a deck in Australia?+

In most states, decks above a certain height off the ground (commonly around 1 metre) require a building permit or approval โ€” rules vary by state and council, so check with your local building surveyor or council before starting.

General information only. This calculator provides estimates for planning purposes and does not constitute financial, tax, legal or medical advice. Figures are based on publicly available Australian rates and rules current as of September 2026; always confirm specifics with the ATO, a licensed adviser, or the relevant government body before making a decision.

Related calculators