๐Ÿ‡ฆ๐Ÿ‡บ Free Australian calculators โ€” rates updated for FY2026โ€“27
Energy & Electrical

Voltage Drop Calculator

Calculate the estimated voltage drop for a cable run โ€” a general reference; all electrical work must be done by a licensed electrician.

๐Ÿ•’ Updated September 2026๐Ÿ‡ฆ๐Ÿ‡บ Australia-specific๐Ÿ’ฏ Free, no signup

๐Ÿงฎ Calculate voltage drop

Voltage drop occurs because every cable has some electrical resistance, causing a small voltage loss proportional to the cable's length and the current flowing through it โ€” negligible over a short run, but potentially significant over a long one, which is exactly why AS/NZS 3000 sets maximum allowable voltage drop limits for compliant electrical installations.

This calculator gives a general estimate โ€” actual cable sizing and all installation work must be carried out by a licensed electrician applying the full AS/NZS 3000 requirements, not a simplified online tool.

The formula

Voltage drop (V) โ‰ˆ 2 ร— Length (m) ร— Current (A) ร— Resistance per metre (ฮฉ/m), where resistance per metre depends on the specific cable's cross-sectional area. The commonly applied guideline is keeping total voltage drop under about 5% of the supply voltage for general circuits โ€” exceeding this can cause connected equipment to underperform or overheat.

Frequently asked questions

What is an acceptable voltage drop percentage?+

A commonly applied guideline under AS/NZS 3000 is keeping voltage drop under approximately 5% of the supply voltage for general circuits, though the exact acceptable limit can depend on the specific circuit and installation โ€” a licensed electrician applies the precise current standard requirements.

Why does cable length matter so much for voltage drop?+

Voltage drop increases proportionally with cable length, since a longer cable has more total resistance โ€” this is why long runs (to a shed, granny flat, or far end of a property) often need a larger cable size than the same current would require over a short distance.

Can I use this calculator to size my own cable installation?+

No โ€” this is a general educational estimate only. All electrical wiring work in Australia legally requires a licensed electrician, who applies the complete AS/NZS 3000 requirements including temperature derating, installation method and cable grouping factors this simplified tool doesn't capture.

Sources & further reading:
General information only. This calculator provides estimates for planning purposes and does not constitute financial, tax, legal or medical advice. Figures are based on publicly available Australian rates and rules current as of September 2026; always confirm specifics with the ATO, a licensed adviser, or the relevant government body before making a decision.

Related calculators