๐Ÿ‡ฆ๐Ÿ‡บ Free Australian calculators โ€” rates updated for FY2026โ€“27
Home Improvement & Construction

Drainage Fall Calculator (Pipe Slope)

Work out the correct slope (fall) for a drainage pipe run, in mm per metre.

๐Ÿ•’ Updated October 2026๐Ÿ‡ฆ๐Ÿ‡บ Australia-specific๐Ÿ’ฏ Free, no signup

๐Ÿงฎ Calculate your drainage pipe fall

A drainage fall calculator works out how much a drainage pipe needs to drop in height (the 'fall') over its length so that wastewater or stormwater flows away properly by gravity, without being so flat that solids settle out and block the pipe, or so steep that liquids outrun solids and leave them behind. Fall is usually expressed either as a ratio (like 1:60, meaning the pipe drops 1 unit for every 60 units of horizontal run) or in millimetres of drop per metre of pipe, and plumbers commonly work in both depending on the job.

Minimum fall requirements for drainage pipework in Australia are set out in the relevant AS/NZS plumbing standards and vary by pipe diameter โ€” generally, smaller diameter pipes need a steeper minimum fall than larger ones to keep self-cleansing velocity up. This calculator converts a chosen fall ratio and pipe run length into the total drop in millimetres you need across that run, which is the figure you'll actually use when setting pipe levels with a laser level or string line on site.

Common fall rates used in Australian drainage

A 1:60 fall (roughly 16.7mm of drop per metre) is a widely used minimum for 100mm diameter sewer and stormwater drainage pipe in Australian plumbing practice, while larger diameter pipes (150mm and above) are often permitted a flatter minimum fall such as 1:100, since the larger cross-section still maintains adequate self-cleansing flow at a shallower grade. Steeper falls than the minimum are generally fine and often preferred where site levels allow, as long as the pipe isn't so steep it creates problems at a downstream junction.

These figures are general industry conventions rather than a substitute for checking the specific AS/NZS 3500 plumbing and drainage standard requirements for your pipe size, material and application, and your local water authority or licensed plumber should confirm requirements for any job that needs council or authority approval.

Setting out fall on site

Once you know the total drop required over your pipe run, plumbers typically set string lines or use a laser level to mark the invert (bottom-of-pipe) level at both the start and end of the run, then check intermediate points as the trench is dug. It's worth building in a small amount of extra fall beyond the bare minimum where site levels allow, since this gives a margin for minor construction tolerances without risking the pipe falling below the minimum required grade.

Frequently asked questions

What is considered a minimum fall for a 100mm sewer pipe in Australia?+

A 1:60 fall is a commonly referenced minimum for 100mm diameter drainage pipe in Australian plumbing practice, though you should always confirm against the current AS/NZS 3500 plumbing and drainage standard and any local water authority requirements for your specific job.

Can a drainage pipe have too much fall?+

Yes, in principle an excessively steep fall can cause liquids to flow faster than solids, potentially leaving solid waste behind โ€” though this is far less common a problem in typical residential drainage than insufficient fall.

Does pipe diameter affect the minimum required fall?+

Yes โ€” generally smaller diameter pipes need a steeper minimum fall to maintain adequate self-cleansing flow velocity, while larger pipes can often use a flatter minimum grade.

Do I need a licensed plumber to set drainage fall?+

For most sewer and stormwater connections in Australia, yes โ€” this work typically needs to be carried out or certified by a licensed plumber and may require council or water authority approval, so check your state's requirements.

General information only. Always confirm minimum fall requirements against the current AS/NZS 3500 standard and your local water authority. Drainage connections typically require a licensed plumber.

Related calculators