A friction loss calculator estimates how much water pressure is lost to friction as water travels along a pipe or hose, which is essential when you're sizing a pump, planning an irrigation system, or working out whether a long hose run will still deliver decent pressure at the far end. Friction loss increases with pipe length and flow rate, and increases sharply as internal diameter decreases — a narrow hose pushing a high flow rate loses far more pressure per metre than a wider one carrying the same flow.
This calculator uses a friction loss coefficient (expressed as metres of head lost per 100 metres of pipe, for a given diameter and flow rate) which you take from a manufacturer's friction loss chart or a standard hydraulics table for your pipe type and size — because friction loss depends on the pipe material's roughness as well as its geometry, there's no single universal formula that works accurately across PVC, poly, and various hose types without that reference figure. Plug in your run length, diameter, flow rate and the matching coefficient, and the calculator scales it to your actual length.
Why diameter matters more than you'd think
Friction loss in a pipe roughly follows an inverse relationship with diameter raised to a high power (close to the 5th power in common hydraulic formulas such as Hazen-Williams), which means even a small reduction in internal diameter causes a disproportionately large increase in friction loss at the same flow rate. This is why upsizing a pipe by even a few millimetres on a long irrigation run can make a noticeable difference to end pressure, and why manufacturers' friction loss tables are organised by diameter first.
Fittings, bends, valves and filters add their own 'equivalent length' of friction loss on top of the straight pipe run — a run with several 90-degree elbows and a filter can lose meaningfully more pressure than the straight-line distance alone suggests, so it's worth padding your length estimate if your system has a lot of fittings.
Using this for irrigation and pump sizing
If you're sizing a pump for a garden irrigation system or a fire-fighting pump setup, friction loss (combined with elevation change) tells you how much extra pressure the pump needs to produce over and above what you want delivered at the outlet. Many Australian irrigation suppliers publish friction loss tables for their poly pipe and drip line products specifically for this purpose — use the table matching your actual pipe brand and class where possible.
Frequently asked questions
Pipe and hose manufacturers publish friction loss tables (sometimes called hydraulic tables) listing head loss per 100m for various diameters and flow rates — check the manufacturer's technical datasheet or an irrigation supplier's design guide.
No — elevation (static head) is a separate factor you add on top of friction loss when sizing a pump; this calculator only estimates the friction component.
Friction loss increases steeply as pipe diameter decreases, because the water has to move faster through a smaller cross-section and encounters proportionally more pipe-wall surface relative to its volume.
Yes, ideally — add an allowance (often called 'equivalent length') for each bend, valve or fitting in the line, which most hydraulic tables express as an extra few metres of straight pipe per fitting.