๐Ÿ‡ฆ๐Ÿ‡บ Free Australian calculators โ€” rates updated for FY2026โ€“27
Home Improvement & Construction

Epoxy Resin Calculator

Calculate how much epoxy resin and hardener you need to fill a mould or casting by volume.

๐Ÿ•’ Updated October 2026๐Ÿ‡ฆ๐Ÿ‡บ Australia-specific๐Ÿ’ฏ Free, no signup

๐Ÿงฎ Calculate resin needed for your project

A resin calculator works out the volume of epoxy resin and hardener you need to fill a mould, cast a piece of jewellery, pour a river table, or coat a surface like a tabletop or artwork. Getting the quantity right matters because mixing too little means you'll run out mid-pour (which can create visible layer lines once cured), while mixing too much wastes an expensive product that can't be put back in the bottle once combined. This calculator works from the volume of your mould or pour area and your product's specified mix ratio.

Different epoxy resin products are sold with different mix ratios โ€” commonly 1:1 by volume for many art and tabletop resins, but some deep-pour and casting resins use 2:1, 3:1 or 4:1 ratios, so always check your specific product's datasheet rather than assuming. The calculator here converts your pour dimensions into a total volume, then splits that volume according to the ratio you select so you know exactly how much resin and how much hardener to measure out.

Why mould shape and shrinkage matter

Resin volume is simply length x width x depth for a rectangular pour, or pi x radius-squared x depth for a round mould or vessel โ€” this calculator does that conversion for you. It's worth adding a small buffer (often 5-10%) on top of the calculated volume, since irregular mould surfaces, bubbles that need topping up, and minor measuring imprecision can mean the exact theoretical volume runs slightly short.

Deep single pours of standard (non-deep-pour) resin can generate significant heat as they cure, which may cause cracking, yellowing or excessive bubbling โ€” most resin manufacturers specify a maximum pour depth per layer (often around 1-2cm for standard resin) and recommend pouring thicker sections in multiple layers, so check your product's datasheet before attempting a deep single pour.

Measuring and mixing tips

Always measure resin and hardener by the ratio specified on your product (by volume or by weight, depending on the brand โ€” check which one your product uses) rather than eyeballing it, since an inaccurate ratio is one of the most common reasons epoxy resin fails to cure properly or stays tacky. Mix thoroughly and scrape the sides and bottom of your mixing container, as under-mixed resin near the container walls is a frequent cause of soft or sticky patches.

Frequently asked questions

How much extra resin should I mix beyond the calculated volume?+

A common rule of thumb among resin artists is to mix roughly 5-10% more than your calculated volume to account for mould surface texture, bubbles and minor spillage โ€” but check your specific product guidance too.

Can I pour a thick layer of any epoxy resin in one go?+

Not safely with most standard resins โ€” thick single pours can overheat, crack or discolour. Check your product's maximum recommended pour depth, and use a dedicated deep-pour resin for thick single-layer pours.

Do all epoxy resins use a 1:1 mix ratio?+

No โ€” ratios vary by product and can be 1:1, 2:1, 3:1, 4:1 or other ratios depending on the formulation, so always check the specific product's instructions.

Does this calculator account for bubbles or shrinkage?+

No, it calculates the geometric volume of your pour only โ€” add your own buffer percentage for bubbles, mould texture and minor losses.

General information only. Always follow your specific resin product's safety data sheet and manufacturer instructions for mix ratio, ventilation and maximum pour depth.

Related calculators