Getting air conditioner sizing wrong is expensive in both directions: an undersized unit runs constantly at full capacity and struggles to reach temperature on hot days, while an oversized unit cycles on and off rapidly ('short cycling'), which wastes energy, wears out components faster, and often leaves a room feeling clammy because it cools too fast without adequately removing humidity.
This calculator applies the common industry rule-of-thumb wattage-per-square-metre method to estimate an appropriate capacity range for your specific room.
The rule-of-thumb calculation
A widely used starting point is roughly 120-150 watts of cooling capacity per square metre for an average Australian room, adjusted upward for poor insulation, high sun exposure (especially west-facing rooms in the Australian climate), high ceilings, or rooms with a lot of glass. This gives a reasonable ballpark, but it's still a simplification โ a proper Manual J-style load calculation (or at minimum, a specific installer's assessment) accounts for far more variables and is worth getting for anything beyond a simple single-room split system.
Why 'bigger is safer' is the wrong instinct
It's tempting to size up 'just in case', but an oversized air conditioner cools the air quickly without running long enough to properly dehumidify it, and cycles on and off more frequently โ both of which reduce comfort and increase wear, despite using more energy than a correctly sized unit running efficiently for longer stretches. Right-sizing (or even slightly undersizing with a well-insulated room) generally beats oversizing.
Frequently asked questions
As a rough guide, around 2.4-3.0kW cooling capacity for an averagely insulated room of that size, adjusting upward for poor insulation, high sun exposure or high ceilings โ this calculator applies that adjustment automatically based on your inputs.
Neither is ideal, but oversizing causes its own specific problems โ short cycling, poor humidity removal and increased wear โ so getting an accurate size (or a proper professional load calculation) is generally better than assuming bigger is always safer.
Yes โ a room with a high or raked ceiling has significantly more air volume to cool for the same floor area, and typically needs a larger capacity unit than a standard-ceiling room of the same square metreage.